Thursday, 9 May 2013

Green Gifting Process

Initial sketches :

Card Models: First I made a model to work out proportions and different angles of elevation.
Then I made the actual lengths of the casing, giving it different heights for the pen holders.



Aluminium extrusion : I decided to give it a brushed finish, to give it a better look, and reduce scratches. This was done with sandpaper in a straight motion.


The caps at the ends can be removed to be used as a pencil case. I tested how much could fit within the casing. The cap was hard to put back on, as it was only a strip of rubber. I would have preferred a moulded cap, but I did not have the time for it. This would have resulted in a better model and fit.

:
Final Model :


No comments:

Post a Comment